Get shopping advice from experts, friends and the community! I bought a used Craftsman Table Saw (model 113.299410) and need to change it from 220v to 110v. Can anyone tell me how to do this? Also how do I get a manual? Thanks Frank. Jun 05, 2017  I posted this originally in the woodworking reddit, but was pointed this way. I am trying to track down an owner's manual for model # 113.299410. In all my google searches, the only one I find is a sub manual for the rail and fence for that saw, and is only 8 pages.

Attention! The text in this document has been recognized automatically. To view the original document, you can use the 'Original mode'.

RULES FOR SAFE OPERATION

READ ALL INSTRUCTIONS

READ THESE INSTRUCTIONS AND THE
INSTRUCTIONS FOR YOUR TABLE SAW
THOROUGHLY before using accessories.

KNOW YOUR POWER TOOL. Read the owner's

manual for the Table Saw carefully. Learn the
saw's applications and limitations as well as the
specific potential hazards related to this tool.

KEEP THE WORK AREA CLEAN. Cluttered

work areas and work benches invite accidents.

DO NOT leave tools or pieces of wood on the
saw while it is in operation.

ALWAYS WEAR SAFETY GLASSES. Everyday

eyeglasses have only impact-resistant lenses;
they are NOT safety glasses.

ALWAYS DISCONNECT SAW FROM POWER
SUPPLY BEFORE MAKING ADJUSTMENTS
OR ADDING ACCESSORIES. Make sure the
switch is off when reconnecting to power supply.

SAVE THESE INSTRUCTIONS. Refer to them
frequently and use to instruct other users. If you

loan someone this tool, loan them these instruc­

tions also.

Look for this symbol to point out important safety precautions. It
means attention!!! Your safety is involved.

LOOSE PARTS LIST

These included parts make up the the fence and rails accessory 929993. Fasteners are shown actual size,

2. Rails

1. Fence

A. Fence............................................................. 1

B. Screw (1/4-20 x 3/8)....................................... 2

C. Fine Adjustment Knob................................... 1

A. Front rail end cap.......................................... 2

B. Screw for end caps (5/32-32 x 1/2 in.)........... 4

113.299410 Parts

C. Rear rail end cap.......................................... 2

D. Front rail........................................................ 1

Craftsman 113 Table Saw Parts

E. Rear rail.........................................................1

B.

Attention! The text in this document has been recognized automatically. To view the original document, you can use the 'Original mode'.

INSTALLATION

INSTALLING THE REAR RAIL

A WARNING:

Front and rear rails must be

carefully aligned to reduce the risk of kickback,
which can cause serious injury.

■ From the carton, remove the rear rail and the

following hardware:

Right and left end caps for rear rail

2 screws (5/32-32 x 1/2 in.) for end caps

Note: The square head bolts, washers, and hex nuts

shown at the top of figure 3 should still be on the

table saw. If you mistakenly removed them, put
them back on the table. Do not tighten.

■ Carefully slide the rail onto the square head bolts.

SQUARE HEAD

BOLT

HEX NUT

■ Position rail so that the right hand edge extends

2-1/2 in. beyond the table extension.

Note: Instructions are given from the operator’s

position in front of the saw.

■ Push the rail against table and tighten each hex

nut with a 12 mm wrench. If the rail jams or does
not slide easily over the bolts, re-align the table
extensions according to the instructions in the table
saw owner's manual.

Note: Make sure there are no gaps between the rail

and edge of table or extensions.

■ Put the end caps on the rail ends. Insert the

screws and tighten with a phillips screwdriver.

1/2 in.

END CAP

SCREW

Fig. 5

Fig. 4